Denver isn’t great with public transport either. There’s at least a minimal light rail system and buses go pretty much everywhere, so that’s the good part, but the city is so sprawled out that unless your destination is a direct route you’re looking at an hour or more to exclusively use public transport. And that’s really the main city. Start getting out into the expanded metro area and there’s not many choices except for a handful of spur rail or bus lines.

It’s a lot more than many American cities, especially on paper, but in practice it’s pretty rough to use as a primary transport.

Yep, using one to run clipper for my 3d printer with armbian as the OS. It’s been rock solid for me. There obviously some adaptation and discovery when trying to use the io as it’s similar-but-not the same as the raspberry pi io and manipulating it is not the same. But it works, it was available, it was competitively cheap, and it’s been stable

Plus I get to say I’m running my 3d printer on a potato